网站首页公司概况 企业荣誉 产品简介 应用行业 科技研发 工程案例 销售网络 联系我们 在线留言
公司简介
发展历史
公司战略
企业文化
全称:河南长兴建设集团材料有限公司
联系人:杨经理
手机:0393-3558666
电话:0393-3323666
地址:河南濮阳市赵村工业园
     首页 >> 产品简介
CX-06:环氧富锌防腐涂料
发布时间:2015/6/24 16:32:06 []人次

 

CX-06:环氧富锌防腐涂料
 
成分性能:由环氧树脂及聚酰胺树脂、超细锌粉、溶剂、助剂等组成。
产品特点:具有阴极保护和屏蔽作用,漆膜坚硬、附着力好、干燥快、耐水、耐油防锈性能优异,低温固化、在-15℃天气情况下可正常施工。
适用范围:用于海洋工程、船舶、油罐、煤气罐、桥梁、铁塔、石油管道等设施钢结构表面中防腐的底漆。
施工说明:混合配比:底漆:固化剂=10:1     熟化时间:30分钟     
适用期:(25℃)6小时     施工方法:高压无气喷涂、手工刷涂、轴涂
稀释剂:CX-稀释剂       最大稀释量:≤5%
涂装间隔:(25℃)最短12小时,最长无限制,(10℃)最短24小时,最长无限制,(30℃)最短6小时,最长无限制。
表面处理:钢材表面经抛丸或喷砂处理,达到瑞典除锈标准Sa2.5级或手工除锈标准St3级。
施工条件:施工温度在5℃以上,相对湿度应小于85%,雨、雪、雾天不宜户外施工。
注意事项:1、涂料现用现配,静置30分钟后再使用。因锌粉比重大,使用时需将漆料充分搅拌均匀 后再加固化剂搅拌均匀。
2、富锌底漆易形成锌盐,在涂装后道漆之前,需除去锌盐及污物,以免影响层间附着力。
3、涂料应存放于阴凉、通风、干燥处。并隔离火种。
4、施工现场应注意通风,雨、雪、雾天不宜户外施工。

 Ingredients: performance is composed of epoxy resin and polyamide resin, solvents, additives, superfine zinc powder.

Product features: with cathodic protection and shielding effect, tough film, good adhesion, fast drying, water resistance, anti rust oil performance excellent, low temperature curing, at - 15 DEG C weather conditions can be normal construction.

Scope of application: used in marine engineering, ship, oil tank, gas tank, bridge, tower, oil pipeline, etc.

Construction Description: mixing: Primer: =10:1 curing agent curing time: 30 minutes

Application period: (25) 6 hours construction method: high pressure no gas spraying, manual brush, axis

CX-: maximum amount of diluent diluent dilution: less than 5%

Coating interval: (25) the shortest 12 hours, the longest no limit, (10) the shortest 24 hours, the longest no limit, (30) the shortest 6 hours, the longest no limit.

Surface treatment: steel surface by blasting or sandblasting, derusting to Swedish standard Sa2.5 level or St3 level standard manual derusting.

Construction conditions: construction temperature at 5 degrees Celsius, relative humidity should be less than 85%, rain, snow, fog days not outdoor construction.

Note: 1, paint is used now, 30 minutes after the use of static. Because of zinc than the major, the need to use the paint mixing after adding curing agent mix.

2, easy to form zinc rich primer zinc salt, before painting the paint, to remove the zinc salt and dirt, so as not to affect the adhesion between the layers.

3, paint should be stored in a cool, ventilated, dry place. And isolated fire.

4, the construction site should pay attention to ventilation, rain, snow, fog days not outdoor construction.

 

下一个:CX-05:无毒环氧树脂防腐涂料
上一个:CX-30:无机硅酸锌防腐涂料
页面功能【打印】【关闭