网站首页公司概况 企业荣誉 产品简介 应用行业 科技研发 工程案例 销售网络 联系我们 在线留言
公司简介
发展历史
公司战略
企业文化
全称:河南长兴建设集团材料有限公司
联系人:杨经理
手机:0393-3558666
电话:0393-3323666
地址:河南濮阳市赵村工业园
     首页 >> 产品简介
CX-07:环氧云铁防腐涂料
发布时间:2015/6/24 16:33:01 []人次

 

CX-07:环氧云铁防腐涂料
成分性能:由环氧树脂、云母氧化铁、铝粉浆、防锈颜填料、助剂、固化剂等组成。
产品特点:漆膜坚韧、附着力好、干燥块、耐盐水、耐热性及防腐蚀性能优良。
适用范围:用作防锈底漆,也可作富锌底漆的中间层,增加封闭性和防腐蚀性能。广泛用于船舶、集装 箱、桥梁、煤气柜、港口机械及各种金属构件、混凝土的防锈防腐涂装。
施工说明:混合配比:底漆:固化剂=6:1     熟化时间:30分钟    适用期:(25℃)6小时      
施工方法:高压无气喷涂、手工刷涂、轴涂
稀释剂:CX-稀释剂      最大稀释量:≤5%
涂装间隔:(25℃)最短12小时,最长无限制
表面处理:1、若直接在技术表面涂装,要求抛丸或喷砂方法处理,达到瑞典除锈标准Sa2.5级或手工除锈标准St3级。
2、涂装有环氧富锌底漆的漆面,如已在大气中长期暴露后,应除去锌盐、油脂和灰尘等污物。
施工条件:施工温度在5℃以上,相对湿度应小于85%,雨、雪、雾天不宜户外施工。
前道配套涂料:Cx铁红底漆、环氧富锌底漆、环氧富锌车间底漆,环氧铁红底漆、无机富锌底漆等。
后道配套涂料:Cx面漆,环氧面漆、丙烯酸面漆、聚氨酯面漆、氧化橡胶面漆等。
注意事项:1、涂料现用现配,静置30分钟后再使用。因锌粉比重大,使用时需将漆料充分搅拌均匀后再加固化剂搅拌均匀。
2、富锌底漆易形成锌盐,在涂装后道漆之前,需除去锌盐及污物,以免影响层间附着力。
3、涂料应存放于阴凉、通风、干燥处。并隔离火种。
4、施工现场应注意通风,雨、雪、雾天不宜户外施工。

 

 

Ingredients: performance is composed of epoxy resin, micaceous iron oxide, aluminum paste, antirust pigments and fillers, additives, curing agent. Product features: film tough, good adhesion, dry block, salt water, heat resistance and corrosion resistance. Scope of application: used as antirust primer, intermediate layer can also be used as a zinc rich primer and corrosion, increased sealing performance. Widely used in ships, container bridges gas cabinet, the port machinery and all kinds of metal structures, concrete anticorrosion coating. Construction Description: mixing: Primer: =6:1 curing agent curing time: 30 minutes for the period: 6 hours (25 C) Construction method: high pressure no gas spraying, hand painted, axis CX-: maximum amount of diluent diluent dilution: less than 5% Coating interval: (25) the shortest 12 hours, the longest no limit Surface treatment: 1, if directly in surface coating technology, blasting or blasting method processing, to reach the Swedish rust standard Sa2.5 level or manual derusting standard ST3. 2, coated with epoxy zinc rich primer paint, such as in the atmosphere after long-term exposure, should remove zinc salt and grease and dust and dirt. Construction conditions: construction temperature at 5 degrees Celsius, relative humidity should be less than 85%, rain, snow, fog days not outdoor construction. Corollary Coating: CX iron red primer, epoxy zinc rich primer, epoxy zinc rich shop primer, epoxy iron red primer, inorganic zinc rich primer. Subsequent coat: Cx paint, epoxy paint, acrylic paint, polyurethane paint, rubber paint and other oxidation. Note: 1, paint is used now, 30 minutes after the use of static. Because of zinc than the major, the need to use the paint mixing after adding curing agent mix. 2, easy to form zinc rich primer zinc salt, before painting the paint, to remove the zinc salt and dirt, so as not to affect the adhesion between the layers. 3, paint should be stored in a cool, ventilated, dry place. And isolated fire. 4, the construction site should pay attention to ventilation, rain, snow, fog days not outdoor construction.

下一个:CX-06:环氧富锌防腐涂料
上一个:CX-30:无机硅酸锌防腐涂料
页面功能【打印】【关闭